Looking for a way to get a bricked Aluratek AIRMM01F back from the dead. It stays on the Aluratek screen, even when I put it into Recovery Mode it flashes back and forth trying the old ShrekW.Bin file. Anyone able to get this back to where you can at least use it as an FM radio and USB player, even if you can't the the ethernet link going? Please let me know. Thanks!
How do you get it in recovery mode? I had mine on 1.19 (I think) and it ran perfectly but I wanted to check the newer firmware so I followed the doc. It rebooted and rebooted again and now only Sagem is showing and status light blinks on the back. I am p*ssed off to say the least since I use this thing every single day.
I think the one I have will end up as parts! Have tried at least four times to get it configured to functionally receive any radio broadcasts. Goes into a continual setup loop even after entering the correct IP information for my link.
Looking for a way to get a bricked Aluratek AIRMM01F back from the dead. It stays on the Aluratek screen, even when I put it into Recovery Mode it flashes back and forth trying the old ShrekW.Bin file. Anyone able to get this back to where you can at least use it as an FM radio and USB player, even if you can't the the ethernet link going? Please let me know. Thanks!
ReplyDeleteHow do you get it in recovery mode? I had mine on 1.19 (I think) and it ran perfectly but I wanted to check the newer firmware so I followed the doc. It rebooted and rebooted again and now only Sagem is showing and status light blinks on the back.
DeleteI am p*ssed off to say the least since I use this thing every single day.
I think the one I have will end up as parts! Have tried at least four times to get it configured to functionally receive any radio broadcasts. Goes into a continual setup loop even after entering the correct IP information for my link.
ReplyDeleteDid you notice that you can open a http:// to the device and it shows a Firmware upgrade form (to choose file and upgrade) ?
ReplyDelete